|
Step#1
Bumper guard installation tools: (i) painters 1” blue masking tape (ii) pencil (iii) high power cutters ***Note: do not use household scissors or pliers as it will not cut the rubber nicely.
|
|
Step#2
Select the correct color. Peel only HALF of the adhesive backing from the sample chip and place on the bumper. Pick the closest match.
Order Color Sample |
| |
|
|
|
 |
Step#3
Measure height of Bumper Guard installation.
|
|
Step#4
Wash the application area and dry completely.
|
| |
|
|
|
 |
Step#5
Measure the bumper to determine required length of bumper guard. If working alone , tape one end of a tape measure to the wheel edge (blue masking tape is used here). Wrap the tape around the bumper from edge to edge
|
|
Step#5
Alternate View
|
| |
|
|
|
 |
Step#6
Use the 1” blue masking tape to mark installation location. You may install the bumper trim under or above the tape. Walk away from the vehicle and make sure the tape is level all around.
|
|
Step#7
Begin installation by pulling off
a foot or so of the adhesive backing.
|
| |
|
|
|
 |
Step#8
DO NOT PRESS DOWN UNTIL BUMPER GUARD IS LEVEL.
Slowly work your way around the bumper using the blue tape as guidance. If you make a mistake gently lift the bumper molding and reposition. |
|
Step#9
Mark excess auto bumper trim using a pencil and clip with straight blade cutters.
|
| |
|
|
|
 |
Step#9
Continuation...
|
|
Step#9
Continuation...
|
| |
|
|
|
 |
Step#9
Remove tape guide and begin pressing down.
|
|
Step#10
Once Bumper Guard is installed at the correct level, press down firmly with the palms of your hands. Doing this will make sure the adhesive bond has adhered properly to your vehicle
|
| |
|
|
|
 |
Step#11
Admire your work...
|
|
|
