Installation Instructions - Bumper Blocker

BumperBlocker installation is fast and easy...

   

Bumper Blocker - Installation Instructions

Quick Install: Attach the product by hooking the end hooks to the bumper edge. The end hooks are flexible, so you can bend them as needed. Adjust the velcro straps to shorten or lengthen the size. Bumper Blocker Instructions.

Step 1 - Bend the flexible end hooks to resemble the letter "L" or "V". The exact configuration will depend on the wheel well shape.

Step 2 - Use the Velcro Straps to adjust the strap size and tension

Step 3 - Hook one end of the product to the bumper edge and while applying tension hook the other end.

Note: Use velcro to adjust the strap size and tension
Step 4 - If attaching the rear bumper protector, you can drop the straps into the trunk area.

Note: Straps may not work with some Minivans & SUVs
 
1
DO NOT BLOCK - rear exhaust pipes, as it may allow dangerous fumes to enter the vehicle. Vehicle should be in an off position. Do not Drive with product attached. Do not use security straps under the front hood (in engine compartment). Remove straps with scissors before installaing near engine.