Bumper Guard - Installation Instructions

(Step1) Clean the install surface of any dirt, grime and oils. Be sure surface is completely dry and clean.
If area is not properly preped the adhesive may not stick properly!

(Step 2) Decide where you want to position the bumperguard along the bumper. To find the best install height for the rear bumper guard, measure from the ground up to the mid point of your license plate.

(Step 3) How do I install the bumperguards straight? (a) apply blue masking tape across the bumper to mark the desired position. Make sure the taped line is perfectly straight and at the desired position and height. You can also focus on the existing lines or contours of the bumper, and use this as a guide.

(Step 4) Peel away the adhesive backing and apply the bumperguard starting at one end of the bumper and continue along to the other side (following the taped line as a guide). Do do not press on hard at this point.

(Step 5) Optional: you can trim the ends of the bumperguard so that it flows with the angle of the wheel well opening.

(Step 6) Apply even pressure across the entire lenght of the bumperguard. Allow the adhesive to set for several hours before use. Try to avoid car washes, etc while bumper protector is bonding

NOTE: Not recommended for repainted bumpers

ADDITIONAL LINKS

Bumper Guard Installation (Front)

Bumper Guard Installation (Rear)

Bumper Guard Removal (Front)

Bumper Guard Removal (Rear)