Bumper Pad - Installation Instructions

Attachment Instructions #1: (MOST COMMON ATTACHMENT OPTION)

Bend the flexible end pieces of the BumperPad so that they form a “U” SHAPED hook.  Note: The shape of the end pieces may vary for different vehicles, and may depend on the contours of your vehicle’s wheel well and bumper.  The placement of the hook may also vary. (We pre-bend the end pieces for convenience, but you may need to make slight adjustments to find a best fit). This step is only done the 1st time you attach the BumperPad.  

Hook a single end piece to one side of your vehicle’s bumper, and while applying tension attach the second end piece to the opposite side.  You may need to adjust the elastic straps to achieve a best fit.  A properly fitted BumperPad should lie firmly across the bumper

Repeat steps 1 and 2 for the front pad.

Once the pads are adjusted to fit the front or rear your vehicle, attachment and removal will take seconds.

Also, send us your pictures and we will post them in our expanding photo gallery page!